Flyer Robot

For my Science Research presentation sophomore year, I built a demo robot to hand out the flyers/ programs to the people who came by. See the video I made of it below:

Device-wise, the robot consists of the following functional parts:

How it works

After the Ultrasonic Sensor registers a new visitor, the Master NXT (“Jeeves”) sends a Bluetooth signal to the Slave NXT (“Alfred”), which would then turn four wheels that push the bottom program into the arm’s gripper.

Then, Alfred closes the gripper to grab the program once its pushed forward enough to hit a touch sensor (that in-focus gray axle extends into the sensor.)

Once a Bluetooth signal is sent back when Alfred finishes, Jeeves uses the Linear Actuators to move the flyer to the desired position.

A second joint, also controlled by Jeeves, assists in handing out the flyer.

Finally, Jeeves once again signals Alfred to let go of the program, and the arm returns to its default position, assisted by two more touch sensors used to calibrate different parts of the arm.

Originally, I’d also planned to use an IMU to measure when the visitor grabs a program and only let go of it then; due to time constraints, however, I decided to just use a two second timer. The arm itself, as you can see in the video, is pretty shaky too, so it would have been hard to filter out those vibrations from those caused by a potential visitor grabbing the program.

Photo gallery